Arduino DCB to MIDI converter

$30-250 USD

已取消

已发布

大约 11 年前

$30-250 USD

货到付款

I need an Arduino sketch that can interface with the legacy Roland DCB-protocol, which is a pre-MIDI serial protocol for communication between musical instruments. The program should be a 2-channel interface, that: 1. Takes a DCB signal on the Arduino's serial input, and translate the values into standard MIDI-data and send these to the Arduino's serial output. 2. The opposite. (Takes a MIDI input signal into the Arduino, and converts it to DCB at the output. 3. The program The DCB protocol is defined like this: [login to view URL]

Arduino

Electrical Engineering

Microcontroller

项目 ID: 4322097

关于此项目

5提案

远程项目

活跃11 年前

想赚点钱吗？

电子邮箱地址

在Freelancer上竞价的好处

设定您的预算和时间范围

为您的工作获得报酬

简要概述您的提案

免费注册和竞标工作

5威客以平均价$218 USD来参与此工作竞价

@yhaat

Hi, I can do this job.

$250 USD 在20天之内

0.0

(0条评论)

5.1

@betaenergy

Dear Sir, We are Reserach and Development company whose working area are : -Digital Motor Control -Analog Design -Electronic Design -Power Electronics -PCB design -Embedded system -Matlab -Simulation of hardware For each concept descriptions are as follows: Digital Motor Control: -3-phase induction motor vector control drive -Flux estimation algoritm generation -DSP(TMS320) implementation on motor drive -Low speed application -Torque and speed loop generation -Control algoritms Analog design -Low power distribution -Noissless special opamp based analog circuits -Analog filters -Orcad simulation of several circuits Electronic Design -RF transmitter and receiver -Bluetooh reader and transmitter -Magnetic reader Power Electronics -Implementation motor drive -AC/DC converter -DC-DC converter -Battery charger -Solar inverter -Renewable Energy simulations -Uninterruptle power supplies PCB design -Schematic design by Altium -PCB design by Altium -Power board design -SMPS board design Embedded system -PIC18,PIC24,PIC30 and dsPIC applications -Ardino -MSP430 -Atmel -DSP(Texas Instruments) -Renesas Matlab -Power Electronics simulation -Motor drive -Wind Energy -Solar Energy -Control applications Simulation of Hardware -Orcad Simulation(TI,National, Linear Tech, Maxim libraries) -LTI -National -Matlab Very important Note: References attached. Please look excel file to see projects which we made until now! Metin

$200 USD 在5天之内

0.0

(0条评论)

4.7

@eried

Hello, maybe I can help you

$250 USD 在30天之内

5.0

(1条评论)

3.0

@usamacpp

piece of cake

$160 USD 在3天之内

0.0

(0条评论)

1.0

@lawrencefrazier

Hello. I have experience with mcu projects involving midi and cv/gate. Have used TI msp430 mcu, and I have basic adurino familiarity, and can work with that platform.

$230 USD 在21天之内