Arduino Pro Mini and SIM800L simple project code

The project need to use:

1. sim800L module

2. arduino pro mini

3. one external imput (ground)

4. one external + output (led) connected to pin 13 on arduino (it will power the led connected to it)

connexions for those to will be:

-from sim800L TX -to- arduino pro mini: pin 5

-from sim800L RX -to- arduino pro mini: pin 6

What will need to do this software:

-at start-up, if sim800L will have a good signal and simcard will be registered on network, OUTPUT 13 of arduino pro mini

will flash slowly like the led that are on the sim800L, indicating signal OK

-when a sms in format: add#1#phonenumber (when phonenumber will be the number to be stored)

will be received to simcard number that is inserted in sim800L module, NUMBER will be stored to sim phonebook with 1 name (1 is the name)

-when a sms in format: add#2#phonenumber (when phonenumber will be the number to be stored)

will be received to simcard number that is inserted in sim800L module, NUMBER will be stored to sim phonebook with 2 name (2 is the name)

-when will be received a sms FROM A NUMBER STORED IN SIMCARD that is inserted in sim800L (name 1 or name 2) in format: #delall# , will be deleted all numbers

that are stored in simcard. Note: that command (#delall#) will be procesed oly if will be received from a number that is STORED in sim phonebook (1,2)

-now, procedure with addphone number will can be repeated

-the last and most important is: when a ground will be applied to pin 7 of arduino pro mini for at least 2 seconds,

A CALL WILL BE INITIATED to the number stored in sim phonebook with the name: 1 .If the call will be rejected, not in service or out of time, CALL 2 WILL

BE INITIATED TO number stored in sim phonebook with the name 2

-if the proces with putting to the ground of pin 7 will be repeated, same rules will be applied.

_______YOU WILL NEED TO PROVIDE ME THE SOFTWARE THAT I WILL UPLOAD TO ARDUINO PRO MINI__________

Finish

Arduino FPGA 微控制器 软件构架 软件开发

项目ID： #11537088

关于项目