Single Garage Design & Three Unit Site Layout

We are undertaking a three unit townhouse development on 1,011m2 site. There is an existing house located at the front left (East) of the block. The washhouse, add-on bedroom & outhouse at the rear of the existing house will be demolished to make way for two new townhouses. A new single car garage will also be built along site the existing house sketched in red with a courtyard behind in purple on the attached Proposed Development v1 A driveway along the right-hand (west) side of the lot provides access to the two new rear units. If you need to clarify anything to complete this task, we can arrange a suitable time to S[Removed by Freelancer.com Admin - please see Section 13 of our Terms and Conditions] We have attached; 1. Site Survey with existing features Site Survey_S7748 Exist [login to view URL] (*.dwg & *.pdf) 2. Townhouse plans for the new units to be constructed Unit [login to view URL] (same plan to be replicated twice) in *.dwg 3. Proposed Development v1 – PDF sketches & notes for detail of the below 4. Site photos 5. Victorian State Planning Guidelines We require the following tasks; 1. Garage Design Design a single car garage of 3.5m X 6m with a roller door at the front & standard hinged door at the rear inset 400mm from the rear left wall & a second door starting 1.22m from the front of the garage along the left hand wall. The roof pitch is 35degrees from the walls. The garage needs to be situation alongside the left-hand (west side) of the existing house on the attached “Site Survey_S7748 Exist [login to view URL]” plan abutting the chimney. The garage, whilst being 3.5m wide, the left-hand side wall be built back to joint the wall of the house (the chimney essentially inside the garage). The front of the garage needs to be set back in line with the neighboring house on the right hand side (west side). Refer attached Proposed Development v1, detailed in red. From the rear right hand (West) corner of the garage, detail a fence toward the rear of the site until reaching the corner of unit two’s garage to create a courtyard. Refer attached Proposed Development v1, detailed in purple. 2. Placement of Rear Townhouses Use the attached plan “Unit [login to view URL]” and duplicate them on the site overlaying them on the attached file “Site Survey_S7748 Exist [login to view URL]”. a. Place the rear unit plan 1m off the rear (south) boundary b. Place the same plan in front of the above plan and behind the front (existing) unit but hard against the garage wall of the rear unit. Both of the rear two units need to be offset from the right-hand (West) boundary sufficient to allow 7m offset from the boundary to the vehicle garage entry. c. Detail a fence from the left-hand (East) rear corner of the middle unit to the Left-hand (East) boundary fence to create a backyard for the rear unit. Refer attached Proposed Development v1, detailed in purple. d. From the left-hand (East) corner of the middle garage, detail a fence to join the rear wall of the front (existing) unit creating a backyard for the middle unit. Refer attached Proposed Development v1, detailed in purple. e. Draw a driveway along the West side of the lot servicing the the rear units & a separate driveway & crossover for the existing front unit. In a separate annexure of the complete site plan; 3. Private Open Space Calculation Calculate the area of the rear courtyards of each lot 4. Vehicle Turning Circles. Detail vehicle turning circles for entry for forward entry & reversing from the garages of the two rear units. Vehicles are required to exit the site in forward motion. 5. Building Shadowing. Detailing the shadows created by the buildings as at 9am & 22nd September 6. Overlooking from Habitable Room Windows. a. A 45 degree view from habitable room windows b. To a distance of 9m c. At a height of 1.7m The completed work needs to be provided in both *.dwg & *.pdf format.