1. water level controller with three stage , when water reaches lower sensor , heater will get on and When water reaches up to top sensor, solenoid will off , in mean time steam will get generated and then water level will come to middle sensor
again solenoid will on as well as heater on ,
2 if water is not available for two minutes system will get off .
3. temperature controller system will get off when set temperature reaches,
[login to view URL] system will get off when set time reaches . i.e. 1mnt to 120 mints..
4 . auto drain
5 . mp3 with sd card
6 humidity display
[login to view URL] display 0.91 inch 128x32 i2c
yes Buddy, a very easy project to deal with,,U will feel brotherhood,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,
Hi,
I hope you are doing well. I have expertise in embedded system programming and development. I have reviewed your project details. I have experience in water level management system development.
I am not able to understand the use of FM in this case.
Can you explain why you want to use FM here?
Looking Forward,
Khawaja
Hello,
Deep is here from Ahmedabad.
I can help you to develop Steam generation panel. I have experience with Water level controller, Temp. controller, Solenoid Valve control, LCD.
Done similar more than 10 similar controllers boards, with a lot more complications than this tasks
the only more is playing MP3.
Also the boards with a Real Time core that make use of DMA, and bootloader.
main controller used was dspic33ep