graphic products design

Handheld hand unit to download computer information from vehicles. Hust the handheld unit. MY Needs: Below: L- 5.25” or 133.35mm W- 3.” or 76.2mm The sizes H- 1.25” or 31.75mm 1. 409, and 427, Two will use a male “three prong” plug (shown in B photo, the thumb side, is angled at a 45 degree angle on both sides). 2. 427 hand held unit on the topside please show three small LED lights (colors, RED, next to the light put “Accident”, GREEN, next to the light put ”Citation”, Blue, next to the light put “Chase”). 3., 454, Will use a male “twelve prong, two rows of 6” plug (shown in B, the thumb side, is angled at a 45 degree angle on both sides). These photos are just small hand units that I have found photos off the internet. I am thinking the photos will help you in your design. The hand units must be very easy to handle, maneuver with gloved hand, very easy to see in day/night, (that’s why the reflective strip for night), dry/wet weather and very good looking with soft rounded corners. Inside the hand units, a computer board with integrated computer chips. The hand unit will encapsulate this computer board. Top, Bottom, both side and a “3d dimension” views, are required. A. The gold cap comes off. C. the receptacle slides out of the hand unit. B. is the one I am looking for. B. A 45% angle at the bottom thumb side, both side will have the same 45% angle on the hand unit. I have the three photos just email me & I will send them to you. You must ask for the photos. (bufordsfun1@[login to view URL]) You will be required to show me your work. Tks Buford