Powershell network interface manager task

已关闭 已发布的 6 年前 货到付款
已关闭 货到付款

To run in the background monitoring network connections to:

Turn off specific WLAN radios if specific Ethernet is connected

Else turn on those radios

Connect to specific WLAN SSID if available, with minimum delay

Priority interfaces is Eth, Wi-Fi1, Wi-Fi2

Assign specific single static IPV4 to the highest priority interface that is connected and remove that IP from other interfaces if present.

So if there is no Eth enable radios and look for SSID. If found connect highest priority Wi-Fi interface to the SSID.

Once connected assign the IP to that one interface.

If Eth is then connected disable radios and assign IP to the Eth.

If Wi-Fi2 is connected and has the IP and Wi-Fi 1 interface is then connected disconnect Wi-Fi2, connect Wi-Fi1 and move the IP to Wi-Fi1.

As long as a connection is possible on any of the three interfaces it should be established on the highest priority and remain stable. If the active connection is lost, due to lost signal, cable disconnection, entering flight safe mode etc attempt connection on next lower priority interface with minimal delay.

Must run on Win7, 8, 10 32 and 64 bit

Solution need not be Powershell but WLANManager example could be a starting point.

[login to view URL]

Native support in stock Windows is preferred.

Powershell软件

项目ID: #16304356

关于项目

4个方案 远程项目 活跃的6 年前

有4名威客正在参与此工作的竞标,均价£524/小时

Jake2Mi

Hi, I am ready to discuss this project and show demo (auto swith between ethernet and Wi-Fi after connection change).

£444 GBP 在10天内
(0条评论)
0.0
amurdoch5

Hi there, this sounds like an interesting project! It should be possible to handle this natively in Windows using PowerShell - so long as any client machines using this have PSv3 and above installed. I hadn't seen W 更多

£500 GBP 在10天内
(0条评论)
0.0