Dc-Dc converter -- 2

$10-30 USD

已关闭

已发布

超过 9 年前

$10-30 USD

货到付款

I want some one to design me dc-dc converter 13v 10A with calculations, proteus schematics and pcb design. The converter should boast up or down, if the battery voltage goes up and down. The boaster should be able to boast up voltage from lower limit 10v. The output should be ripple free and should have a smooth output. Also the output should not be inverse polarity.

Electrical Engineering

Electronics

Embedded Software

项目 ID: 7087347

关于此项目

14提案

远程项目

活跃9 年前

想赚点钱吗？

电子邮箱地址

在Freelancer上竞价的好处

设定您的预算和时间范围

为您的工作获得报酬

简要概述您的提案

免费注册和竞标工作

14威客以平均价$69 USD来参与此工作竞价

@aliserbetci

Bir öneri henüz sağlanmadı

$25 USD 在3天之内

5.0

(38条评论)

7.5

@kingch91

I have seen and understand your requirements please open chat window to discuss further ----------------------------------------------------------------------------------------------------------------------------------- I am expert of electronics, and i will deliver you work on time, and assure you will surely like my work. Please lets discuss further I will provide you simulation in proteus and you can see all the results please discuss further...

$30 USD 在3天之内

4.9

(187条评论)

6.9

@EagleSha

Over 12 years of experience in electronics hardware and software design. Proficient in software and hardware design of embedded systems. Successful in planning and management of entire development and production cycle. Programming languages: C, C++, Ada, Pascal, MATLAB, GPSS, VHDL Processor architectures: 8051, AVR, ARM-M3, ARM-R4, ARM-7, x86, PicoBlaze, PSoC, PIC FPGA and CPLD architectures: Cyclone, MAX, Spartan, CoolRunner

$64 USD 在10天之内

4.9

(32条评论)

5.9

@bchandra1955

This bid is just for design ................For simulation in MULTISIM additional $40.................Creating PCB and to realize the prototype parts cost + $100 will be reaquired

$80 USD 在4天之内

4.5

(69条评论)

6.1

@janjiczika

I am electronics engineer, currently employed in factory which is producing led modules and electronic ballasts. Good with PSpice and Altium.

$35 USD 在1天之内

5.0

(1条评论)

0.4

@HaykNersesyan

Hello. Please make interview if you really want high quality working example design. As i understand you are not hardware engineer (boast up or down). DC/DC boost converter is voltage step up, and DC/DC buck converter is voltage step dawn. So you will need 2 schematic on 1 PCB. one step up converter, one step down converter, and it should have option to automatically switch between these 2 converter. Regards. Hayk.

$111 USD 在2天之内

0.0

(0条评论)

0.0

@azimjs

Hello Sir, What you are asking is a Buck Boost Converter. So is that what you want ? And do you want the output to be constant or dependent on the voltage ? Please get back to me. Thanks

$50 USD 在1天之内