STM32L0 SPI SD FATFS

Hi, I am an electrical engineer with experience of four years in embedded and power electronics industries. I am working on STM32F4 since last 3 years. Specifically i am using STM32F407VGT6 and i have designed my own interfacing board to enhance the feature of Discovery board. With this i have connected MCP3302(SPI ADC), MR44V064A(I2C FeRAM), GSM(SIM 900), ESP8266(UART to Wi-fi) and OTG USB Keyboard also. I am very much proficient in Embedded C programming and keil uVision also. Do let me know if you have any queries/questions. Let us at least get into the interview stage and discuss things. Hoping to hear from you, Jaydip Kathiriya

I can do it. Perhaps you already have a diagram (description) of your hardware, I can see what pins are being used and which is clocked by F073?

Hi, I am very much interested in your project as I believe I have the expertise, knowledge, skills and tools to do your project. I am embedded software developer with more than 8 years of experience of professional embedded software development. Please take a look onto my profile to know more about me. I have quite a lot experience of ARM processors specifically Cortex M0/M3/M4. I have written and used low level, middleware as well as higher level code. I have J-link debuggers, couple of STM32F development boards (STM32F107, STM32F446, STM32F429, STM32F405, STM32F412 and STM32F407). I have quite a lot experience with IAR, ARM GCC and Keil compilers. I would like to participate in this project as Senior Embedded Software Developer. My recent STM32 projects that might tell you my knowledge and experience, 1. STM32F407 Discovery based CAN Data logger to log CAN data into SD Card (SDIO mode) and emulate USB MSC device to read/write SD Card data and Custom HID implementation to send/receive interrupt data. 2. STM32F405 based FATFs to read/write SD Card (both SDIO and SPI) 3. STM32F429 based FATFs to read/write USB mass storage 4. STM32F100 based sesnor board (Reads sensor using 24bit ADC over SPI, and send reading to PC using FT232 USB chip 5. STM32F407 discovery board to read via I2C BNO055 9 DOF IMU senor and save readings as CVS file using ChanFs (FATFs). Looking forward to hearing from you soon. Ibrahim

Hello. I've written FAT drivers for SD cards so I have a lot of experience with the layers of communication between an MCU and an SD card. I've also worked extensively with STM32s and can efficiently develop the needed firmware. Contact me to discuss details.

Hello! My name is Jackie. Currently, I am working as a freelancer programmer. I joined many projects to work with electronic circuits and make firmware for micro controller, such as: PIC, Atmega and STM32. I am good at C/C++ and have a lot of experience of STM32 so I make sure to finish your project well. I am looking forward to hearing from you.

I have been working on a GPS project for car which has saved GPS data to SD card (FatFS) with STM32F103VET6 connect SPI. So I have code and functions for the SD card. So with STM32L0 nothing will be difficult for me. I will send the source code to you after 2 days if I am accepted. Thanks