Embedded Programmer and Linux device driver developer

Tasks outlined: 1. we will provide source code and you extract on .tgz file 2. look over project materials, change source codes from nand to emmc uboot, buildroot and linux 3.10 3. create new environment to build image for flashing with phoenixsuit 4. Install and compile dependencies camera, wifi, #Solve the problem of kImage generating zImage, or directly set lichee/brandy/u-boot-2014.07/tools to the environment variable PATH sudo apt-get install -y u-boot-tools 5. modify & compile uboot, adjust sys config, for all relevant environments - uboot201407/tools/buildman/[login to view URL] class Board: """A particular board that we can build""" def __init__(self, status, arch, cpu, soc, vendor, board_name, target, options): """Create a new board type. Args: status: define whether the board is 'Active' or 'Orphaned' arch: Architecture name (e.g. arm) cpu: Cpu name (e.g. arm1136) soc: Name of SOC, or '' if none (e.g. mx31) vendor: Name of vendor (e.g. armltd) board_name: Name of board (e.g. integrator) target: Target name (use make <target>_config to configure) options: board-specific options (e.g. integratorcp:CM1136) """ [login to view URL] = target [login to view URL] = arch [login to view URL] = cpu self.board_name = board_name [login to view URL] = vendor [login to view URL] = soc [login to view URL] = [[login to view URL], [login to view URL], [login to view URL], self.board_name, [login to view URL], [login to view URL]] [login to view URL] = options self.build_it = False MMC Support: The MMC controller on the Intel PXA is supported. To enable this define CONFIG_MMC. The MMC can be accessed from the boot prompt by mapping the device to physical memory similar to flash. Command line is enabled with CONFIG_CMD_MMC. The MMC driver also works with the FAT fs. This is enabled with CONFIG_CMD_FAT. CONFIG_SH_MMCIF Support for Renesas on-chip MMCIF controller CONFIG_SH_MMCIF_ADDR Define the base address of MMCIF registers CONFIG_SH_MMCIF_CLK Define the clock frequency for MMCIF CONFIG_GENERIC_MMC Enable the generic MMC driver CONFIG_SUPPORT_EMMC_BOOT Enable some additional features of the eMMC boot partitions. CONFIG_SUPPORT_EMMC_RPMB Enable the commands for reading, writing and programming the key for the Replay Protection Memory Block partition in eMMC. cd $CURRENT_PATH/lichee/brandy/ source [login to view URL] -p sun8iw17p1 - A. We will provide update sys config settings fex file B. linux-3.10/drivers/media/platform/sunxi-vin/vin-mipi *photo & parameter settings* IMX 35 func. [login to view URL] C. wifi Put the linux4.9 driver provided by Quanzhi to the directory lichee\linux-4.9\drivers\net\wireless\xr829 and modify lichee\linux-4.9\drivers\net\wireless\Makefile lichee\linux-4.9\drivers\net\wireless\Kconfig These two files, pay attention to the compatibility with the public version of the XR819 module, as follows: - - 7. Compile the kernel First configure .buildconfig cd lichee ./[login to view URL] config Welcome to mkscript setup progress source [login to view URL] 8. product img file and upload code on github Requirements: You need to be expert in Linux know coding and put together kernels for pcb boards before